EQUALLOGIC PS SERIES RESET PASSWORD

September 2, 2020 posted by

Connect the console cable and start Putty on your PC http: Spare disk drive 6 added. As always before performing anything; check, double check, test and always ensure you have a backup. Secondary controller CEMI firmware version: Spare disk drive 0 added. Your email address will not be published. Would you like to configure the array now? All contents is provided “AS IS” with no warranties, and confers no rights.

It appears that the storage array has not been configured. Secondary controller CEMI firmware version: Designed and Hosted by Andy Barnes. At this point, you should set the grpadmin account password to a known value. There are 1 outstanding health conditions. Executing as active control module in slot 0. You assume all risk for your use.

Spare disk drive 7 added. Connect to the SAN via a serial cable to the active storage processor. When the member restarts, the PeerStorage login prompt appears.

Control modules are initializing. Designed and Hosted by Andy Barnes. Control modules have completed initiali zing, and failover is now operational.

Spare disk drive 1 added. Use the procedure described in the Modifying Accounts section in the Group Administration manual or use the following command: Password recovery modeā€¦ Temporarily resetting grpadmin password.

  SILONG MOVIE ONLINE STREAMING

After a short pause, the following message should appear: Home About Cookies Download Script. Just to note you do not need to powercycle the san to do a password resetplease check here http: Spare disk drive 6 added.

Dell Equallogic password reset

Active controller CEMI firmware version: This will halt the boot process and allow you to enter commands to the boot monitor. Wed Dec 19 Whilst the information provided is correct to the best of my knowledge, I am not reponsible for any issues that may arise using this information, and you do so at your own risk.

December 10, at 9: Connect the console cable and start Putty on your PC http: Turn off eqaullogic Power to your EQL. May 8, at 6: The SAN will then reset and reboot, ready for initial configuration. Your email address will not be published. If you get the previous message, log in the group using the grpadmin account and its factory-set password, grpadmin: September 5, at 9: Leave a Reply Cancel reply Your email address will not be seies.

The result is the elimination of all group and volume configuration information and any volume data residing on the array.

  RESENSI FILM KOMANDO SAMBER NYAWA

June 30, at There are 1 outstanding health conditions. Warning health conditions currently exist. It appears that the storage array has not been configured.

Spare disk drive 0 added. EqualLogic RInc. At this point, you should set the grpadmin account password to a known value.

Spare disk drive 5 added. Would you like to configure the array now?

You assume all risk for your use. As always before performing anything; check, double check, test and always ensure you have a backup.

To continue using , please upgrade your browser.

equallogix Proudly powered by WordPress. Reset this array to factory defaults? Secondary controller CEMI firmware version: Control module failover cannot occur u ntil the initialization completes. May 3, at Spare disk drive 4 added.